Editing How to Assemble a Diaper Genie II



Assembling a Diaper Genie II is relatively simple and can be done in just a few steps. Here's how to assemble a Diaper Genie II:

1. Gather all the parts: The Diaper Genie II comes in several parts that need to be assembled. Make sure you have all the parts, including the top lid, bottom bin, and the refill cartridge.

2. Attach the bottom bin: Take the bottom bin and snap it into place on the base. Ensure that the bin snaps securely onto the base.

3. Install the refill cartridge: Take the refill cartridge and slide it into the holder at the top of the Diaper Genie II. Ensure that the refill cartridge is securely in place.

4. Thread the refill: Pull the end of the refill through the slot on the top of the Diaper Genie II, making sure to leave a bit of slack.

5. Attach the lid: Take the lid and snap it into place on top of the Diaper Genie II. Ensure that the lid snaps securely onto the top of the device.

6. Prime the Diaper Genie II: To prime the Diaper Genie II, push down on the refill cartridge several times until the film is taut.

7. Start using: Once the Diaper Genie II is assembled and primed, you can start using it. Simply open the lid, insert the dirty diaper, and push it down into the device. The Diaper Genie II will twist the diaper into the refill, locking in odors and keeping your nursery fresh.

With these simple steps, you can quickly and easily assemble a Diaper Genie II and start keeping your nursery clean and odor-free.