Editing Openai/691bd7e6-2c00-8006-a0ff-8447f126175d (section)

=== I’ll describe it using the diagram you posted: ===

==== On the Strandberg diagram, remove: ====
* Neck green (outer coil tap) going to the switch
* Bridge whatever coil tap wire is there (likely red/white tied and sent to switch)

Bare Knuckle Peacemaker wire colors:
* Black = hot
* White + red = series link
* Green + bare = ground

Since you're not splitting, twist + solder white/red together and insulate — do not connect to switch.

This simplifies things.

==== ### ====

Bridge hot → output
Neck hot → output

And both must be connected to the output only in position 2.

On the super switch:
* Find the bridge hot pole (where bridge hot currently goes for position 1)
* Find the neck hot pole

Then:

===== (usually the yellow wire going to the volume pot) =====

This gives you:

➡️ Parallel full humbuckers

==== Series wiring means: ====

Bridge hot → output
Bridge ground → Neck hot
Neck ground → ground

But ONLY in Position 3.

===== Instead of connecting neck hot to output: =====

➡️ Neck hot in Position 3 lug → connect to Bridge ground

Bridge ground is the green + bare on a Bare Knuckle.

Strandberg diagram uses a different color, but the bridge ground is already on a pot shell.

So:

===== This creates: =====

Bridge → Neck → Output
(in series)

==== - 1: Bridge HB ====
* 4: Neck split/parallel depending on your choice
* 5: Neck HB

They still work because we didn’t touch those lugs.